Acknowledge ground fault message and short-circuit message without linked variable create unnecessary output windows messages

• Related Articles

• Unnecessary messages created on standby server after primary server takes over.

  Summary Unnecessary messages created on standby server after primary server takes over before initial messages(created on standby server) were acknowledged. Those messages stay in its message control queue, and continuously create CEL entries until ...

• Checklist: Message Control

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• zenon Editor Output Window and substitution dialog. The screenname is missing if the linked symbol has invalid variable substitution and the question mark will be shown if the variable is invalid.

  Summary When a linked symbol has invalid variable substitution for example the variable didn't exist, then a question mark ? will be shown at the dialog for the substitution. And when the zenon Runtime files are created there is a warning message in ...

• Send Message function does not send messages when triggered by limit without alarm class/group/area

  Summary If a Send Message function is triggered by a limit violation which has no alarm group/class/area linked to it, the Send Message function is suppressed if another alarm group/class/area is suppressed. Description If a Send Message function is ...

• Load Management, by generators, does not consider the variable linked for standby output

  Summary Load Management (former EMS module), by generators does not consider the variable linked as dynamical value of standby output. The value of variable is ignored and Load Management uses fix value configured in Editor. Description Load ...