COPA-DATA Self Service Portal

Disclaimer

This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

COPA-DATA reserves the right to change this document from time to time at own discretion.


Ing. Punzenberger COPA-DATA GmbH
Karolingerstraße 7b · 5020 Salzburg · Austria
www.copadata.com

    • Most Discussed Topics

    • 61850 communication issue with bufferd RCB RCB

      Hi I have configured a buffered Report Control Block (RCB) in a Siemens relay and imported the ICD file into zenon. However, zenon is not enabling the buffered RCB. What could be the reasons preventing zenon from enabling the report? I have already configured

    • CEL logging

      Hi all, I have question about logging in CEL. We use INT variable for commands (MOTOR_CMD), with the following values 0 - IDLE 1 - START 2 - PAUSE 3 - STOP CEL logging activated via dynamic element and checked Old and New value. So, when operator press

    • Automatic Line Coloring in Zenon Energy Edition 8.20

      I'm working on a substation SCADA project using Zenon Energy Edition (v8.2) and need guidance on setting up Automatic Line Coloring in Zenon Energy Edition for the single line diagram. My goal is to change the colour of lines, busbars, and breakers based

    • IEEE C37.118 data archiving every 20 ms

      Hello, We would like to archive PMU datas. We are getting PMU datas over IEEE C37.118 Zenon logic drive to the Zenon Energy Edition 14. And Resolution of PMU datas are 50 samples per seconds. It can be 200 samples per seconds in some special application

    • Driver errors

      Hello, Please refer to the attached photo, whenever we run the runtime we are always experiencing 100% CPU usage which causes the server to be unresponsive and takes a long time to load. Many drivers are showing this error. Please advise us on how to