COPA-DATA Self Service Portal

Disclaimer

This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

COPA-DATA reserves the right to change this document from time to time at own discretion.


Ing. Punzenberger COPA-DATA GmbH
Karolingerstraße 7b · 5020 Salzburg · Austria
www.copadata.com

    • Most Discussed Topics

    • Show user that changed value of variable on a report

      Hi! This question is between Engineering Studio and Report: There is a way to save the username from a user that changed the value of a variable on the same dataset (Img 1) as the variable data, so I am able to make a table with a column describin the

    • PMU Datas Archiving

      Dear Sir/Madam, I would like to archive PMU datas. I am getting PMU datas over IEEE C37.118 logic drive. Resolution of PMU datas is 50 messages per seconds. So I need to archive these datas each 20 miliseconds. So my question is that how should i set

    • Issue in MFM Integration with SCADA via MODBUS RTU

      I am trying to integrate an MFM with the SCADA system via the MODBUS serial protocol. I have added the ModRTU32 driver to the project and created holding register-type variables of 'Real' data type under this driver. During testing, the variables were

    • String in Interlocking Formula

      As title say, can I use a string value from a variable in the interlocking formula? If so, how? For example: -Thanks!

    • Alarm duration

      Is it possible with the "Alarm Active" Time to combine every time the alarm appeared. I want to see the top 5 occurring alarms with total time active