zählenden Heartbeat

zählenden Heartbeat

Hallo zusammen,
ich versuche gerade einen Heartbeat für eine externe SPS zu erzeugen. Die INT Zahl soll sekündlich hoch zählen. Bei 1000 soll der Wert auf 0 Springen und wieder hoch zählen.
Hoch zählen habe ich über eine Zeifunktion und einer Sollwert_absetzen-Funktion gemacht. Null Problemo. Allerdings weiß ich nicht wie man den Zähler wieder zurück auf 0 gesetzt bekommt.
jemand eine Idee :confused:

This is a migrated post! Originally posted on 13.11.2014 by user sebiko. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com