Time variable, min / max values in report and RGM table

Time variable, min / max values in report and RGM table

Hi all.
I use time varibale from Siemens PLC. Imported as DINT in zenon with signal range min 0 and max 60000000. Measuring range min 0 and max 1000. So with this we get minutes. 
Now when we open RGM or report min and max ranges for variable are min -35791 and max 35791.
How to get measuring ranges here min 0 and max 1000?
One solution is to use INT varibale in zenon and convert it to time in PLC.
But we are concerned is there possibility to do it on zenon?

BR

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com

      • Topic Participants

      • milos