SICAM 230 with ABB RTU560CMG

SICAM 230 with ABB RTU560CMG

I am trying to replace MicroSCADA SYS 500 with SICAM 230 6.51 to communicate with ABB RTU 560CMG. I can communicate with the RTU over ethernet but i can not send any commands to RTU. I have the IEC 104 parameters taken from RTUtil560 as excel export. My question is which values do i have to enter for O1, O2, O3, O4, O5 and what else should i do for completing this project. I have just started to learn about SCADA so if you take a look at the files and tell me your opinion i will be very gladfull.

This is a migrated post! Originally posted on 21.03.2012 by user onder89. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com