Report Enable, COT0 and COT1 status bit for variables

Report Enable, COT0 and COT1 status bit for variables

Dear Mr./Mrs.
I hope have a good time and answer my question quickly!,.
I define IEC850 drivers for P442, P643, P642, F650 and P14NB protection relays. For F650s and P14NB relays when report are enables, you see the status bit of all variables are COT0 and COT1 simuntanouesly, means zenon get the variables value by report. In these devices, when fault is ocurred all the value read by zenon driver and everything is ok. But for P442, P643 and P642 when we define report and enable by zenon, only COT1 is registered for variable status, means only data value read by integrity time, in this state some variables value change is not send by report automatically and some data are missing when fault is created (AML and CEL pages, For example you see some times DIFF trip signal and sometimes you cant see this signal) how can i change driver setting to see COT0 and COT1 simultanoueslly in status bit?

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com