Problem with ReMa, 61850 Report communication and delay time

Problem with ReMa, 61850 Report communication and delay time

Hello,
I have a problem with delay in reaction matrix in zenon energy 8.00.
I'm using a 61850 driver with Report Enable (All my data points are tagged with COT0, COT1 ). I configured a Binary Rema with a short delay (5s) to create a new entry in alarm list for the exceeed time of intermediate position (value 2) of a DPI Position point of a Swithgear.
I receive correctly the intermediate state but the ReMa if the 5s intermediate position time expired, doesn't create a new entry in my alarm list.
If I set up a 0s delay, the entry in alarm list is showed (but to early!).
If I try to run the driver in simulation mode and then I force the intermediate state, the ReMa create correctly a new entry in alarm list after 5s.
I think that the ReMa is correctly configured, but i don't know why with the real 61850 driver, i can't set up a Delay on a new entry.

thank you for the answer!

This is a migrated post! Originally posted on 16.04.2019 by user doublem. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com