Problem with 61850 driver
I have a problem with 61850 driver in zenon.
On my Laptop I have zenon 6.22 SP0. I connected it to a BCU and imported some command and response variables from 850 driver.
Commands Data Type: BOOL
Response Data Type: DINT
When the command variable was 0 the response variable in zenon was 0
When the command variable was 1, the response variable in zenon was 1
It was working the same as it should and I could easily send commands from command picture without any problem.:)
----------------------------
Our customer has the same zenon 6.22 SP0 on his PC
When the command variable was 0 the response variable in zenon was 64
When the command variable was 1, the response variable in zenon was 128 :eek:
The poroblem on this PC was that I couldn't send commands on/off correctly and I didn't know how to make the Reaction Matrices. I made different ReMas but none of them worked properly.:confused:
(The hardware, variables and all setup in both projects were the same)
I tried to solve this problem with the zenon 6.22 SP1, but it had the same problem.
Do you know:
-Where this difference in the value of the response variables is comming from?
-How I should set the Reaction Matrices? Should the ReMas be the same for both commands and Response variables?
Thank you and sorry for my long post,
Shahrzad
This is a migrated post! Originally posted on 10.05.2009 by user shahrzad. Please be aware that information can be outdated.
Disclaimer
This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.
The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.
Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.
Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.
COPA-DATA reserves the right to change this document from time to time at own discretion.
Ing. Punzenberger COPA-DATA GmbH
Karolingerstraße 7b · 5020 Salzburg · Austria
www.copadata.com