Problem in Trend for IEC61850 data

Problem in Trend for IEC61850 data

Hi Experts,
I have read few analog parameters through iec 61850 driver.
I have configured them in historian with on change recording, but I am not getting any trnd on trend display.it shows blank or a straight line. I have also checked in archive, no value is getting stored.
if I change recording to cyclic recording with 1 sec .it shows me the value.
I tried by changing polling time from driver from 10 ms to 1000ms etc ..it haven't worked.
I am using zenon supervisor 7.10.
Pl help
Regards,
VInay

This is a migrated post! Originally posted on 19.05.2014 by user askrajput. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com