IEC61850, import variables from driver

IEC61850, import variables from driver

When using the "Import variables from driver" for IEC61850 protocol in zenone 7.5 - variables are not downloaded in full. We have access only to the variables available for display (read area) only . Access to a variable with the ability to send control commands to the relay is absent - and there is no difference the way of getting variables: downloading variables directly from the device or obtaining them from a previously saved configuration (*.cid, *scd) . Variables using to send control actions to relay - are "cut off". We did the same in MicroSCADA from ABB - please, see attached picture with area marked by red color - this variables are not accesible using "Import variables from driver" for IEC61850 protocol in zenone.
What we are doing wrong?


This is a migrated post! Originally posted on 05.10.2016 by user igor_tobilevych. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com