ETM internal functions

ETM internal functions

Hi,
I am using Zenon 6.22 SP1 Build 0. I have made a picture of type ETM and put the default control buttons. There is one control button 'Diagram', which when clicked shows a small window in which you can edit the Trend diagram (Axis and curve options). I want that this small window should appear in the center of the screen (Right now it is appearing near the control button which is in the left bottom of the page). How can I achieve this target?
Regards

This is a migrated post! Originally posted on 23.02.2010 by user shikra. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com