establishing connection

establishing connection

hi i'm using zenon 7.6 with abb ac500 plc's, i have 1 driver of 3S_V3 with 20 controllers.
in the office i have only 1 or 2 plc's, when i check the programs, every time i open or reload the runtime it takes forever to establish connection to the plc.
i set the timeout in the driver to 2000ms and the retries to 1 and it still takes a lot of time.
when there is only 1 plc in the driver everything is O.K.
is there a why to tell the driver to try connecting only to the connected plc?
thank's

This is a migrated post! Originally posted on 17.04.2018 by user eden212. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com