I need to disable certain machines or parts of machines due to maintenance or because they are not yet fully implemented.
We are using Equipment Modeling to define machines and their components. However, I’m trying to figure out how to disable alarms for only specific equipment. I can see options to disable alarms based on alarm groups or classes, but not directly by Equipment Group.
Interestingly, in the Message Control settings, it is possible to suppress messages for specific Equipment Groups. Why isn't a similar mechanism available for alarms? This inconsistency is confusing.
Is there a way to disable alarms for a specific Equipment Group, similar to how it works in Message Control?
This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.
The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.
Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.
Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.
COPA-DATA reserves the right to change this document from time to time at own discretion.
Ing. Punzenberger COPA-DATA GmbH
Karolingerstraße 7b · 5020 Salzburg · Austria
www.copadata.com