Data Pulling With same PLC different Data type

Data Pulling With same PLC different Data type

Hello. I have an issue, i have a case an PLC have Coil status for breaker ON, OFF and trip and Also they have power meter in Holding register. I try configure different Variables, different Driver but same IP and Device ID. but the result when i start service engine. Only can show 1 side sometime only Coil status and the Holding register cannot pulling data. And also some time only holding showing and coil cannot pull data. Any advice?
but in modscan everything looks fine, i can read coil status and also holding at the same time

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com