ConnectionState variable

ConnectionState variable

Hi! I'm using Zenon Energy Edition v7.6 with the IEC61850 !ConnectState Variable to detect communication error for ALM with a certain IED in my project. But the variable never goes to TCP_CONNECT_ FAILED when i disconnect the RJ45 cable from that IED it just keeps at TCP_CONNECTING. Is there another diag variable that I should use to detect comm errors or am I just using the !ConnectState the wrong way.

This is a migrated post! Originally posted on 23.10.2018 by user pernilsson. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com