Communication Between Zenon to RS Logix-5000

Communication Between Zenon to RS Logix-5000

Dear Support Team,
I am using Zenon 7.00
I am trying to do the communication between Zenon to RS Logix-5000 with RSLinx Classic gateway using Emulator.
Allen-Bradley ODVA driver:
I did the configuration in SCADA as follows,
1. Driver Configuration (Ref: ODVA Driver_config.jpg):
I assigned the Net address is "1" and used this same in variable. Is this related with RSLogix-5000 or RS Linx...? If it is, where can I see in PLC side...?
CPU slot number is "3". This is the slot number assigned in RSLogix-5000 and Emulator (RS-Logix 5000 Controller.jpg). Is this correct...?
2. Variable Configuration (Ref: Var_Config.jpg):
Net address is same which is assigned in driver configuration. I assumed the Bit number "0" is the first bit used in RSLogix-5000. Is it correct...?
3. RSLinx in SCADA machine:
Emulator (AB_VBP-1) and RSLogix machine (IP: 192.168.1.59) is running (Ref: RS linx sts.jpg).
Please explain me If I need to do any further settings or correction in the existing configuration.

Allen Bradley RS-Linx driver:
Please explain the following things for the configuration of Allen Bradley RS-Linx driver,
1. I selected the PLC type as a PLC2. Is this correct for RSLogix-5000 run by Emulator...?
2. Please guide me where can I see the Net address, PLC2 data table address, File number and Element in the RSLogix-5000 or RSLinx (Ref: RS linx sts-Driver.jpg).
Best Regards,
A. Navaneet.

This is a migrated post! Originally posted on 30.04.2014 by user navaneet. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com