Beckhoff Twin Cat NG Treiber nicht ausführbar

Beckhoff Twin Cat NG Treiber nicht ausführbar

Hallo,
wenn ich im Zenon Supervisor 7.11 (64Bit) den Treiber Beckhoff TwinCt NG Treiber in meinem Projekt hinzufügen möchte, passiert gar nichts. Es wird weder ein Konfigurationsmenü, noch irgendetwas anderes angezeigt. Nach kurzer Wartezeit, indem Zenon arbeitet und nicht reagiert, ist alles so wie vorher, aber leider ohne den Treiber aktivieren zu können.
Gibt es dazu eine Lösung bzw. ist das Problem bekannt?
MfG
Robs

This is a migrated post! Originally posted on 06.01.2015 by user robs. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com