Alarm screening

Alarm screening

Hi, this is my problem...
I have 3 buttons for 3 units.
In every unit I have about 50 alarms.
Button should flash in red color when new alarm in specific unit occur.
If alarm is still active after being acknowledged in AML, button should stop flashing, but stay in red color.
If alarm become inactive before being acknowledged in AML, button should flash in green color.
After acknowledge inactive alarm in AML, button should be in basic color without flashing.
Can you guide me step by step, how to make it work?
Thanks in advance.
Regards.

This is a migrated post! Originally posted on 23.04.2013 by user tihomir. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com