150 Pumps

150 Pumps

Hy!
In meinem Projekt gibt es ca 150 Pumpen gleicher Bauart.
Ich will die Störungen dieser Pumpen in einem Popup darstellen.
Dieses Popup soll durch drücken auf das Pumpensymbol geöffnet werden.
Die Namen meiner Variablen lauten wie folgt :
PU001_ST1, PU001_ST2, PU001_ST3
PU002_ST1, PU002_ST2, PU002_ST3
.
.
.
PU150_ST1, PU150_ST2, PU150_ST3.
Nun habe ich ein Bild mit meinen 3 Störungen gezeichnet und mit PU001 animiert.
Durch die Funktion Bildumschaltung – Verknüpfungen ersetzen werden die anderen Pumpen popups auch richtig aufgeschalten.
nun mein Problem:
Ich muss dafür nun 150 Funktionen erstellen. Ist noch ok.
Wenn sich aber nun etwas ändert(z.B.: wenn eine zusätzliche Störung (ST4) dazukommt) muß ich wieder alle 150 Funktionen öffnen und die „nderung nachführen.
Daher meine Frage ob es einen einfacheren Weg gibt diese Popups zu adressieren.
Ich hoffen dass mir jemand dabei helfen kann!
mfg Leo.

This is a migrated post! Originally posted on 19.12.2008 by user lunzer. Please be aware that information can be outdated.

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com